![]() ![]() If the enter key is pressed again on the calibration point the following screen is opened. This will be indicated with a lock symbol in the upper left corner of the screen.Ī practical way to calibrate the machine is to place a sheet of material between the tools and find the Y-axis position at which the punch just touches the sheet (pinching point). Note: when enter the enter key is pressed without the specified code the calibration point will be displayed but cannot be changed (read only). In this example the calibration point is 105.71mm. Enter code 456 and press enter.Īfter the enter key is pressed the following screen will be displayed. To set the calibration point, select the service parameter in the program constants menu. This procedure has to be repeated each time the height of the tools that are mounted in the machine are changed. ![]() This calibration point parameter is available in the program constants menu. In other words, the Y-axis position that corresponds with the situation where the lowest point of the punch is at the same level as the upper side of the V-die (pinching point with sheet thickness = 0). This parameter defines the Y-axis position when the tools are closed. To calibrate the bending depth calculation the calibration point must be programmed. The program number remains, but the number of steps is reset to 0. To delete a program, move the cursor to the program number and press the clear key. When a program has been selected, the control automatically switches to the programming mode.Ī program remains active until another program is selected or until it is deleted. Then use the arrow keys to get to the correct program number. The cursor will automatically jump to the group of numbers that begin with this digit. 74), press the first digit of this number (e.g. To select a program with a high number (e.g. This program number is also displayed in the upper right corner of the screen, beside the mode symbol. To select a program, move the cursor to the required program number and press ENTER to select it. As soon as a program has been selected, one step is added to the program. ![]() By default, all programs consist of 0 steps. To edit a program, it must be selected first. There are 100 product programs available in the control. The symbols above each column have the following meaning: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |